For the rubber flexible connection, one end will be itself with the butt flange docking. The other end and the butt receiving carry out electric welding welding, in the whole process of electric welding need to prevent the sealing ring in heat destruction. In the process of tightening the screw cap, in order to make the bearing capacity of the sealing ring symmetrical, the screw cap nut must be tightened evenly at the top corner, and a few tightening before symmetrical replenishment. Secondly, the original situation of the rubber joint after the pipeline equipment is carried out should be in line with the provisions of the equipment trick. Note that the spacing limit L between the two screw caps (or between the screw cap and itself) is the same, and within the limits specified by the main parameters of the commodity trick, the amount of expansion is guaranteed to be satisfactory for the processing process, and the amount of expansion cannot be occupied because of the engineering construction requirements.
Rubber soft connection such a raw material in the specific development of the use of the course, will have a variety of different assembly methods, but there are cases you can find assembly of rubber soft connection, they will have a variety of different characteristics, and in some cases you will thoroughly experience such a raw material, in the course of assembly is very easy to feel nothing improper areas, no What is incorrect, in fact, not so, there are some people in the case of installation, if there are some small areas did not pay attention to the words, they often cause the rubber flexible connection assembled by some items can not be all normal operation, so this incorrect all completely preventable, in this case, in many cases you can find, assembly of rubber flexible connection will occur a variety of different In such cases, you can find that the assembly of rubber flexible connections will occur in a variety of different operating errors.
